Note：

The polymeric resin used in Durakote FRPNC 660 reacts with moisture. Please ensure can is resealed after use. Durakote FRPNC 660 is supplied ready to use, no shaking or mixing is required. Do not mix with other products or solvents.

For new, porous or damaged moulds, Duraktoe 615 should be used for applying the Durakote FRPNC 660. See Durakote 615 technical date sheet for application details.

Application：

Please read Safety Date Sheet before use.

If necessary, polish mould to desired level of gloss. If a wax or silicone based release agent had been used previously, remove traces of previous product using a solvent based cleaner such as Durakote PMC-600.Durakote FRPNC 660 can be applied over existing semi-permanent release agents without a further cleaning step. However the mould should be clean and dry before use. Mould cleaning and release agent application should be performed in a well-ventilated area

1.Apply Durakote FRPNC 660  to clean, dry cotton cloth.(certain synthetic cloths are also suitable)

2.Gently wipe over mould surface covering an area of approximately 1-2 m². Vigorous rubbing or polishing is not required..

3.Wait for 10-15 seconds then, with a second dry cotton cloth, gently wipe over the wet coating to leave a thin wet film. Do not wipe dry. Vigorous rubbing or polishing is not required.

4.Repeat until mould is completely coated.

5.When dry, allow a further 10 minutes between coats for the film to cure.

6.Repeat step 1-5 above for a further 2 coats (3 in total)

7.Repeat step 1-6above for a further 3 coat (4 in total)

8.When dry, allow final film to cure for at least 30minutes at room temperature before moulding. Allowing a longer cure or 

heat curing (e.g. 15 min at 60℃) will improve film durability.

Reapplication:

When the release becomes hesitant, reapply one coat of Durakote FRPNC 660 in the same manner as described above.

Please contact us for further product and application information.