Products
Contact Us
- Address：Suite 807, TianAn Hi-tech Development Plzaza. No.555 North PanYu Road, PanYu DistrictGuangZhou, China.
- Tel：020-39211238
- Fax：020-39211286
Durakote 615
Brands：Durakote
Types：
Field of application：
Introduction：Durakote 615 is designed as a mould sealer for glass reinforced polyester(gel coated or non-gel coated GRP), vinyl ester, epoxy or metal moulds. Durakote 615 is an advanced polymeric resin in an organic solvent blend. The resin both seals micro porosity and fills minor scratches on the mould surface resulting in a smooth, high gloss surface primed for Durakote top-coat application. Durakote 615 is especially recommended for use on new moulds and repaired areas on older moulds.
|
Product Benefits |
Physical Properties |
|
l Efficient mould sealer and primer l Easy application l Enhances mould gloss (see application details for appropriate coating technique) l Low odour l Minimal mould build-up l Versatile, can be used on all mould surface l Durable; provides semi-permanent base-coat for mould release agent |
Appearance - Clear, colourless liquid Odour - Hydrocarbon Specific Gravity - 0.743 g/cc Flash Point - >24℃ Solvent - Aliphatic hydrocarbon Coverage - 80-100 m2/L per coat Shelf Life - One year Storage - Flammable store(see MSDS) |
Note：
The polymeric resin used in Durakote 615 reacts with moisture. Please ensure can is resealed after use. Durakote 615 is supplied ready to use, no shaking or mixing is required . Do not mix with other products or solvents.
Application：
Please read Safety Date Sheet before use.
If necessary , polish mould to desired level of gloss. Durakote 615 should only be applied to clean and dry mould surfaces. If a wax or silicone based release agent had been used previously, remove all traces of previous product using a solvent based cleaner such as Durakote PMC-600. Mould cleaner and Durakote 615 application should be performed in a well-ventilated area.
1.Apply Durakote 615 to a clean , dry cotton cloth.
2.Gently wipe over mould surface covering an area of approximately 0.5-1 m2。
3.Wait 10-20 seconds（until the edges of the wet film start to dry), Using a second dry cotton cloth gently
spread the wet film. Do NOT wipe dry. Vigorous rubbing or polishing is not required.
4.Repeat until mould is completely coated. Ensure each application area overlaps the last to ensure complete
coverage.
5.Allow at least 10 minutes to cure between coats.
6.Repeat Step 1-5 above for a further coat (2 in total)
7.Allow final film to cure for at least 30 minutes at room temperature before applying Durakote top-coat.
Allow a longer cure or heat curing(e.g. 10 min at 60℃) will improve film durability.
Please contact us for further product and application information.
service
Manager Du
Hotline：