Physical Properties

Appearance               ：colourless

Water，ppm          ：≤500

Release Power，N/100cm2   : ≤40

Viscosity，mPa .S (25℃): 160-240

Specific Gravity   ：1.02g/cm3

The surface of show    ：Shine and smooth

Application：

1, The release agent with 120# gasoline diluted to the appropriate concentration, because the soles of men and women in the release of the degree of thermalization is not the same, in the dilution release agent, should be diluted by men and women soles of the requirements were diluted. The dilution ratio shall be determined according to the specific process of the plant. The proposed multiple is 20 - 40.

2, Spraying (or brushing) before the release agent, the mould must be cleaned with solvent, be sure to make the mould surface without rust or other pollutants, and then coated with release agent used.

3, The first spraying release agent, be sure to increase the amount of spraying.

4, The spraying release agent must be evenly distributed throughout the mould surface, can not be left dead corner, the edge of the mould should be appropriate to increase the amount of spraying.

5, After finishing the release agent, and other solvent evaporation, wipe the surface of the mould with a dry cloth and then inject material.

6, It is necessary to ensure that the container and compressed air are dry and moisture free. Otherwise, it is difficult to release.

7, release agent not unused to fall back to the original packaging barrel, to prevent pollutants release agent.

Package

30KG/Durm